PDA

Просмотр полной версии : Значение ПЧ в Power SDR



RW9SZ
05.03.2007, 07:25
В каких максимальных пределах можно "менять" частоту ПЧ для Power SDR и как высчитывать эти изменения? (Т.е. при изменении частоты ПЧ с 11025 на 12000 в Clock offset пишем -58740. Это имперически подобрано или можно как-то пересчитывать?) Есть ли какие либо "подводные" камни в выборе частоты ПЧ? Т.е. почему 11025 а не выше? Есть ли связь частоты ПЧ и скоростью обработки при одном и том буфере обмена?

RW3PS
05.03.2007, 10:01
Значение Clock offset под ПЧ 12000 подобрано как вы говорите имперически.
В пользовательском мануале вот что сказано:
Manual Calculation
The calculation for the DDS adjustment is not complicated. Divide the DDS frequency (200MHz) by the
known signal frequency (say, 10MHz WWV) and then multiply by the difference between the known signal and
the measured signal. For example, say you tune the VFO to 10MHz and the peak shows up at 9.999700MHz
(difference is 10.0 – 9.999700 = +300Hz). The Clock Offset would be 200/10 * 300 = 6000. Plugging in 6000
into the Clock Offset control should zero beat the signal. The frequency offset is the actual clock oscillator
offset from its nominal 200MHz output. The oscillator is rated at 100ppm, which yields a maximum offset of
+/- 20KHz from 200MHz. Note that if the measured frequency were 10.000300MHz, the offset would be -
6000. Fine adjustments may be made directly on the Clock Offset control on the General Tab of the Setup
Form.